Complete drilled fully floating stainless steel EBC Brake Disc. Used for rear and front left hand brake disc for Le Mans 1000, 1000S. Rear brake disc only on Cali 3, Cali 1100, Spada 3, Strada 1000

Also known as Guzzi ref 28613660, 30635860. This is an update to the non floating disc ( 28613300 / 28613301 ) fitted to front of Nevada, Lario, T5, SP II, Monza 2, V75 and V35 3. Always fit new brake pads when replacing a brake disc - BRA54724 . Use disc bolt BRA30460

 2 in stock

28613670-z 28613670 GU28613670 28 61 36 70
 2861 3670 2861.3670 28.61.36.70

Brembo pad pin kit for Brembo F05 (P5) calipers. Contains one long pin, two short and retaining spring

Brembo ref. 120280010, also used on some Laverdas . Front calipers only on Strada

 2 in stock

 39659100 GU39659100 39 65 91 00
 3965 9100 3965.9100 39.65.91.00

Also fits Benelli 250 TS

Split pin for brake pedal pivot

 2 in stock

 95500227 GU95500227 95 50 02 27
 9550 0227 9550.0227 95.50.02.27

Rebuild kit for Brembo Goldline Calipers with 34mm / 30mm pistons. Contains seals, brake grease and instructions in English. One kit required per caliper. Also suitable for some Ducati / Aprilia models.

Caliper seal kit

 2 in stock

Pair of EBC FA047 sintered brake pads for Brembo F05 (P5) and Grimeca calipers for extra braking power

Fits Nevada up until frame no. LK112433 Fits all calipers on pre 1993 models

 2 in stock

27654610-z 27654610 GU27654610 27 65 46 10
 2765 4610 2765.4610 27.65.46.10

Also fits Benelli 250 TS

Pair of organic EBC FA256 rear brake pads

Twin pin fitting. Pre 2012 V7 models use a different brake pad with only one pad pin hole. Also known as Guzzi ref 2R000248

 2 in stock

AP8133798

Front brake master cylinder cap and rubber kit for Brembo PS 13 master cylinder. Check the screw holes in your master cylinder are diagnally opposed (as seen top left and bottom right corners when sitting on bike)

Reservoir cap replaces Guzzi ref. 2B001928

 2 in stock

 03661145 GU03661145 03 66 11 45
 0366 1145 0366.1145 03.66.11.45

The innovative stahlbus bleeder valve allows you to change the brake fluid yourself without assistance.

Linked Guzzi brake systems are notoriously tricky to bleed, this special bleed nipple can save you hours of tedious squeezing and pumping!

• Completely sealed by O-ring.
• Hydraulic system remains sealed even during the venting process.
• Reliable non-return function on this auto bleed valve, thus one-man operation.
• System has been bled in minutes.
• Wear of the threads in the caliper is prevented (up and screwing down during the bleeding process).
• For all hydraulic systems such as brakes and clutches stahlbus brake bleed valve just replaces the existing vent screw.
• Tested under extreme conditions by TÜV Rheinland.
  See BRA41652 for bleed valve cover. Fits front calipers only on models listed above.

   2 in stock

  [ CLOSE WINDOW ]
  [ CLOSE WINDOW ]

Universal hydraulic brake light switch. This hydraulic switch replaces discontinued brakelight switches by bolting in place of a single banjo bolt on the handlebar or rear brake master cylinder

NB stop light switch may be supplied with or without 2 pin block connector. Can be used in place of Guzzi ref. 32657060

 1 in stock

Brembo pad pin kit for Brembo P4 30/34F calipers fitted to front forks, two pins

Brembo ref. 120394230

 1 in stock

 01659130 GU01659130 01 65 91 30
 0165 9130 0165.9130 01.65.91.30